Description of the productGypsum fibre board for the highest insulation.
Gypsum fibre boards should be stored in horizontal position on wooden pallets or strips of boards in dry, moisture-protected rooms.
Versions for edging the edges
SK edge – open joint – board width 1195, 1245 mmAlign the boards on a 5-7 mm joint and fill the joint completely with Uniflott. Scrape the excess after approx. 40 minutes. Apply Uniflott with trowel or wide steel scraper and embed joint tape into it.
Using a suitable gun, apply a continuous bead of Knauf Vidiwall Joint Adhesive to the adjacent edge of the fixed board. Align the next board and push it firmly into the bed of adhesive (joint width <1 mm) and fix it with screws or staples. Scrape off the excess Knauf Vidiwall Joint Adhesive within one hour with a steel scraper.
SK edge – glued joint – board width 1199, 1249 mm
When should the joint-filling be carried out?
- When no significant changes in the length of the gypsum fiber boards are expected (eg due to changes in humidity or temperature) ››The air humidity is between 40 and 75%
- The room and surface temperature is not less than 10oC
- All statically relevant weights must be introduced before joint-filling z. B. underlay floors, roofing, green roofs etc.
The gypsum fibre boards with a thickness of up to 12.5 mm are cut with a scraper blade and bent over the edge of the rack. The broken edge can be aligned with a front grate and cleaned from dust (especially when applied with an open or glued joint). Clean edges can be achieved with an electric saw (use aspiration).
FixingGypsum fibre boards are fixed to metal frame by means of screws and to timber frame by means of screws, nails or staples (DIN 1052), galvanized or with another